CVE-2019-5544 - Security Notice: Information regarding recently discovered OpenSLP vulenerability
  HP Anyware uses OpenSLP library which has been reported affected by CVE-2019-5544. HP Anyware does not believe the vulnerability is exploitable on either the Zero Client or  Remote Workstation Card but as an absolute guarantee customers may want …
Knowledge Base Article Advisory Security Management Console Remote Workstation Card Zero Clients
Last modified: August 7, 2023
285
How does PCoIP share bandwidth over the network?
The BW Limit is dynamically calculated and represents the bandwidth the PCoIP session estimates to be available given the network conditions. The calculation takes into account the existing bandwidth usage, packet loss and any high latency spikes. The …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
284
What does "MCU not initialized" log message mean?
Problem You are unable to manage a zero client using the HP Anyware PCoIP Management Console 1.x (MC). The event logs reveal the following MCU errors: LVL:1 RC:-500        MCU :(tera_mcu_read_eeprom_bit): Cannot read from EEPROM, MCU not initialized. …
Knowledge Base Article Troubleshooting Management Remote Workstation Card Zero Clients
Last modified: September 19, 2023
278
The incorrect workstation powers on when trying to connect to a PCoIP Remote Workstation Card from a PCoIP Zero Client
Problem You might encounter the following problem if you use a PCoIP Zero Client to switch between workstations, i.e. computers with a PCoIP Remote Workstation Card (host card) installed: the first workstation wakes up and connects normally, but the …
Knowledge Base Article Troubleshooting Remote Workstation Card Zero Clients
Last modified: September 19, 2023
270
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
264
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
261
How do I configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card?
There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card. Option 1: Use the PC NIC and PCoIP Host Software  For instructions, refer to How do I remotely power on the host PC/workstation through its network interface …
Knowledge Base Article Tutorial Setup Remote Workstation Card
Last modified: August 23, 2018
256