Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4888
What is monitor emulation on the PCoIP Remote Workstation Card and how does it work?
Answer: Monitor emulation is a feature on the PCoIP Remote Workstation Card (also known as a host card) that ensures graphics cards see a valid EDID on a Display Port or DVI port on boot. This helps prevent the graphics card from driving DVI signals or DP …
Knowledge Base Article Advisory Display Setup Remote Workstation Card
Last modified: September 3, 2023
2198
How do I access CTRL-ALT-DEL on a touchscreen monitor with Windows 7?
Answer: In Windows 7 environments where a touchscreen monitor uses the onscreen keyboard, consider enabling CTRL+ALT+ DEL, also known as the Secure Attention Sequence (SAS): Log in to the remote workstation or virtual desktop with the appropriate …
Knowledge Base Article Troubleshooting Setup Display Remote Workstation Card Zero Clients
Last modified: September 21, 2023
2164
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2501
Why do I get a gray screen when connecting from the HP Anyware PCoIP Software Client to a PCoIP Remote Workstation Card?
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …
Knowledge Base Article Troubleshooting Display Remote Workstation Card
Last modified: September 3, 2023
2720
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3543
Why am I experiencing poor performance when playing a 1080p high fps video with my PCoIP Remote Workstation Card and PCoIP Software Client?
Problem When using the PCoIP Software Client to connect to a PCoIP Remote Workstation Card I cannot achieve high frame rate playback.   Cause There are a number of factors that can contribute to poor performance so the best method of trying to determine …
Knowledge Base Article Troubleshooting Display Performance Remote Workstation Card
Last modified: September 3, 2023
1596