Is there any bandwidth consumed when a PCoIP device is idle?
The idle bandwidth depends on the PCoIP host type. Below are the idle bandwidths for different host types: HP Anyware 2.12 and newer, the idle bandwidth consumed is 1-2 kbps. VMware View 4.5 (using PCoIP Software 3.5) and earlier, the idle bandwidth …
What happens when a PCoIP Packet is lost in transit?
When a PCoIP packet is lost or considered lost, the PCoIP protocol makes an intelligent decision on if the packet should be re-transmitted. PCoIP packets containing audio and sometimes imaging may never be re-transmitted as the next sample of audio or new …
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
What does GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout mean in the log?
Problem Message GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout is found in host or client log file.   Cause GSOAP is the protocol used by the PCoIP Management Console 1.x. This error is caused by a socket being opened by GSOAP and not closed …
When accessing the support site, cannot download documents or binaries, and never move past the spinning cursor
Symptoms When downloading documents or binaries associated with PCoIP, the support site shows a spinning circle and eventually times out without showing any content.   Causes The page content contained embedded elements that were blocked by some sites. …
Core API vs Session Client API
  The following page details and compares the Core API and Session Client API in the following area's: Feature Set Supported Host Platforms Direct Connection Licensing   Core API vs Session Client API Feature Set The following table details the feature …
The PCoIP Hardware Accelerator ESXi driver does not report the card temperature
Problem When running pcoip-ctl -I on an ESXi host with the PCoIP Hardware Accelerator drivers installed, the output does not display the CPU and Ambient Board Temperature.   Cause When using an MXM PCoIP Hardware Accelerator in an HP blade, the …