Troubleshooting Management Console Connectivity with Firmware 20.01
Firmware version 17.05 or 20.01 or newer is intended to be managed by PCoIP Management Console 20.01 or newer. HP Anyware recommends upgrading to PCoIP Management Console 20.01 prior to deploying firmware 17.05 or 20.01. Before using PCoIP Zero Client or …
How do I check for packet loss on the ESX interface?
If there is packet loss on a PCoIP protocol session, but an analysis of network devices in the path show no loss and they have been properly configured (see  Network session checklist for PCoIP protocol LAN and WAN deployments ) then you may want to …
VMware ESXi, Horizon View, and PCoIP software compatibility matrix lists
Note: This knowledge base article contains information for VMware Horizon view 6.1 and prior. For the latest information please visit the VMware site. You will be able to find matrices relating to the following: VMware Horizon (View)   ESXi - Build …
Configuration of smart cards with PCoIP Zero Clients and VMWare Horizon
This article is provided to help administrators in setting up smart card authentication in zero clients connecting to VMWare Horizon. This article has been reviewed against the following supported hardware and software versions: VMware Horizon 7.2 PCoIP …
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
PCoIP Zero Client refuses to connect to a View Connection Server
This is a common issue we run into especially when we depreciate older security components from our firmware. We ran into this issue when we depreciated TLS1.0 and are once again seeing it mow that we have depreciated TLS1.1 The typical message the user …
Linux DHCP server configuration when using DHCP Discovery on PCoIP Management Console 2.x and 3.x
Answer: This is based on PCoIP Management Console 2.x and newer only This is an example of configuring a Linux DHCP server when using DHCP Option for device discovery. The DHCP server is configured by editing the configuration file: /etc/dhcpd.conf This …
How do I determine how much bandwidth a PCoIP Protocol Session is consuming?
There are multiple options to determine how much bandwidth a PCoIP protocol session is consuming.   Viewing live data on a PCoIP Zero Client or PCoIP Remote Workstation Card The active PCoIP protocol session bandwidth can be viewed in the PCoIP Zero …