No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
279
In VMware Horizon View, what does it mean when a particular USB issue happens on both the VMware View client and the PCoIP Zero Client?
Answer: If a USB peripheral has the same issue on both PCoIP Zero Clients and VMware View clients (repurposed PC, notebook or thin client running the View Client), it's likely that the issue is in the VMware virtual USB hub driver, or is an issue with …
Knowledge Base Article Troubleshooting Peripheral Devices Third Party Enhancements Zero Clients
Last modified: September 3, 2023
261
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
263
Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
240
Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
238
Why can I not establish a PCoIP session when using (IDN) characters in my HP Anyware environment?
Answer: Internationalized Domain Names (IDNs) are not supported by the HP Anyware. In environments that use the HP Anyware PCoIP Connection Manager and Security Gateway, a PCoIP session will not launch when one or more IDN characters (i.e. ? ? ? ?) are …
Knowledge Base Article Troubleshooting Session HP Anyware
Last modified: September 19, 2023
226
Why can a session not be establish after a user disconnects while the Windows "waiting for programs to close" dialog is showing?
Problem When disconnecting a PCoIP session while Windows is shutting down or a user account is logging off with the "waiting for programs to close" dialog is showing; the ability to reconnect the PCoIP session is lost.    Cause When Windows is shutting …
Knowledge Base Article Troubleshooting Session HP Anyware
Last modified: November 17, 2022
227
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
Knowledge Base Article Troubleshooting Session Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 7, 2023
196