Configures the PCoIP transport header
Configures the PCoIP transport header with the following options: When set to Enabled , the configured session priority of high , medium , or low is used. When set to Not Configured , then the default of medium session priority is used. When set to …
Knowledge Base Article Tutorial Session HP Anyware
Last modified: September 19, 2023
594
How do I disable login username caching on a PCoIP Zero Client?
On a PCoIP Zero Client, username caching is set in the advanced options and can be disabled from the OSD Screen, the Administrative Web Interface (AWI), or the PCoIP Management Console.    From the OSD Screen: Under Options, select Configuration In the …
Knowledge Base Article Tutorial Setup Management Session Management Console Zero Clients
Last modified: September 3, 2023
593
ICMP packets are being send from the machine at the start of the PCoIP session
Problem At the start of a PCoIP session a network trace or firewall logs are recording ICMP packet being sent from the machine. Further investigation shows they are from the PCoIP Server process. PCoIP server logs show a trace route log of up to 30 hops. …
Knowledge Base Article Troubleshooting Session Performance HP Anyware
Last modified: September 19, 2023
588
Can I use an Ethernet hub or half-duplex network connection with a PCoIP Zero Client or PCoIP Remote Workstation Card?
No. PCoIP technology requires a full-duplex Ethernet connection from end to end. In modern networks, half-duplex links can still exist when using technologies such as Wi-Fi or point to point Wi-Fi or Microwave links. Older communication equipment in wired …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: March 26, 2021
550
The PCoIP session ended abruptly and the PCoIP Zero Client PCoIP Splash screen appears
Problem Occasionally issues can cause the PCoIP Zero Client to reboot. Issues such as the ones listed below are good signs that the PCoIP Zero Client has rebooted even though at first it may not be certain the PCoIP Zero Client rebooted. Unexpectedly the …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: September 21, 2023
541
How does device discovery work with the PCoIP Management Console 2.x and 3.x?
The PCoIP Management Console must discover all of the PCoIP devices that it manages and therefore supports the discovery of devices using three mechanisms: DHCP Option discovery DNS DNS Service Record Discovery DNS-Based Discovery Prefix Manual Discovery …
Knowledge Base Article Tutorial Performance Management Console
Last modified: September 3, 2023
543
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
Knowledge Base Article Advisory Session Remote Workstation Card Zero Clients
Last modified: July 3, 2020
530
Why does my Tera2 PCoIP Zero Client perform poorly on a WAN, compared to a software client on the same network?
If you are experiencing refresh issues of image data when scrolling through text and/or images using a PCoIP Zero Client on a WAN network, ensure that you enable the Low Bandwidth Text Codec (LBTC) setting. Note: The LBTC setting is available on TERA2321 …
Knowledge Base Article Troubleshooting Performance Zero Clients
Last modified: August 2, 2023
490
No audio when using Unified Communications with a USB headset
Problem Some users have reported no audio when using Unified Communications solution in firmware 4.7.0, they can only hear the ring of the incoming call and when the call is answered there is no Rx/Tx audio.   Cause This issue has been tracked down to the …
Knowledge Base Article Troubleshooting Performance Peripheral Devices Zero Clients
Last modified: November 7, 2022
476