Reverting to Legacy Certificates after changing the PCoIP Management Console 2.x and 3.x certificate causes the web interface to fail to load
Problem The certificate of the PCoIP Management Console has been updated but the web interface now fails to load.   Cause After uploading the new certificate to the PCoIP Management Console, if your any reason that certificate is not supported, the web …
Knowledge Base Article Troubleshooting Security Management Console
Last modified: November 9, 2022
316
How long before a PCoIP Management Console certificate expires should I replace it?
Before the PCoIP Management Console certificate can be replaced, the new certificate or the signing root CA certificate must be installed in the PCoIP Zero Client or PCoIP Remote Workstation Card certificate store. Once a PCoIP Endpoint is manged by an …
Knowledge Base Article Advisory Management Security Management Console
Last modified: September 19, 2023
285
CVE-2019-5544 - Security Notice: Information regarding recently discovered OpenSLP vulenerability
  HP Anyware uses OpenSLP library which has been reported affected by CVE-2019-5544. HP Anyware does not believe the vulnerability is exploitable on either the Zero Client or  Remote Workstation Card but as an absolute guarantee customers may want …
Knowledge Base Article Advisory Security Management Console Remote Workstation Card Zero Clients
Last modified: August 7, 2023
280
Why do PCoIP Zero clients fail to establish Imprivata OneSign sessions when the OneSign Appliance Verification setting equals no verification?
This happens when the PCoIP Zero Client trust store contains a certificate issued by the OneSign server that does not match the certificate used by the OneSign server.   Workaround Ensure the PCoIP Zero Client trust store does not contain …
Knowledge Base Article Troubleshooting Security Zero Clients
Last modified: September 14, 2023
274
No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
268
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
260