Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Configures the PCoIP transport header with the following options: When set to Enabled , the configured session priority of high , medium , or low is used. When set to Not Configured , then the default of medium session priority is used. When set to …

Knowledge Base Article Tutorial Session HP Anyware

Last modified: September 19, 2023

572

Is there any information left on my PCoIP Zero Client after a reset is performed?

When a PCoIP Zero Client is factory reset, the following information will still reside in flash: If a PCoIP Zero Client is connected to a network during the reset process, the logs will catch the normal network information on start up as part of its …

Knowledge Base Article Tutorial Security Zero Clients

Last modified: November 18, 2022

208

Why can I not establish a PCoIP session when using (IDN) characters in my HP Anyware environment?

Answer: Internationalized Domain Names (IDNs) are not supported by the HP Anyware. In environments that use the HP Anyware PCoIP Connection Manager and Security Gateway, a PCoIP session will not launch when one or more IDN characters (i.e. ? ? ? ?) are …

How to configure the PCoIP MTU Size variable

PCoIP Software Session Variables provide an easy and flexible way for administrators to tune and configure a PCoIP session if required. This article discusses changing the PCoIP session MTU size. Decreasing the MTU size may only be required if PCoIP …

Knowledge Base Article Tutorial Session Setup HP Anyware

Last modified: September 4, 2023

1949

The PCoIP Security Gateway is failing a security scanner with SSL certificate errors

Problem When running a security scan against the PCoIP Security Gateway, it fails based on factors such as: SSL Certificate - Subject Common Name Does Not Match Server FQDN port 4172/tcp over SSL SSL Certificate - Signature Verification Failed …

Why do PCoIP Zero clients fail to establish Imprivata OneSign sessions when the OneSign Appliance Verification setting equals no verification?

This happens when the PCoIP Zero Client trust store contains a certificate issued by the OneSign server that does not match the certificate used by the OneSign server. Workaround Ensure the PCoIP Zero Client trust store does not contain …

Can virtual channels cause issues with a PCoIP session?

Usually this is not an issue. However, if a virtual channel created by a third party is not properly created, it can cause unpredictable results with a PCoIP session or the displayed output. This should be considered as a possible source of an identified …

ICMP packets are being send from the machine at the start of the PCoIP session

Problem At the start of a PCoIP session a network trace or firewall logs are recording ICMP packet being sent from the machine. Further investigation shows they are from the PCoIP Server process. PCoIP server logs show a trace route log of up to 30 hops. …

How do I determine if a PIV card supports T0 or T1 protocol?

This article discusses two simple methods to identify the protocol your Personal Identity Verification card uses. These are shown below. 1. Look up the card's datasheet and it should say which protocols it supports. This requires knowing the card's exact …

How can I tell if the 802.1x certificate uploaded successfully?

A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics