Why do PCoIP Zero clients fail to establish Imprivata OneSign sessions when the OneSign Appliance Verification setting equals no verification?
This happens when the PCoIP Zero Client trust store contains a certificate issued by the OneSign server that does not match the certificate used by the OneSign server.   Workaround Ensure the PCoIP Zero Client trust store does not contain …
Knowledge Base Article Troubleshooting Security Zero Clients
Last modified: September 14, 2023
274
No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
268
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
260
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
257
In VMware Horizon View, what does it mean when a particular USB issue happens on both the VMware View client and the PCoIP Zero Client?
Answer: If a USB peripheral has the same issue on both PCoIP Zero Clients and VMware View clients (repurposed PC, notebook or thin client running the View Client), it's likely that the issue is in the VMware virtual USB hub driver, or is an issue with …
Knowledge Base Article Troubleshooting Peripheral Devices Third Party Enhancements Zero Clients
Last modified: September 3, 2023
252
Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?
No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol.  Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …
Knowledge Base Article Advisory Performance Third Party Enhancements HP Anyware
Last modified: September 3, 2023
234
Local Administrative Password setting is disabled after changing the firmware version in the profile in the PCoIP Management Console 3.0.0
Problem After changing the firmware version in a profile in PCoIP Management Console 3.0.0 the Local Administrative Password setting is no longer enabled and the password field is blank.   Cause This issue is known to happen when the following conditions …
Knowledge Base Article Troubleshooting Security Management Management Console
Last modified: November 7, 2022
215