Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

When the network experiences periods of high congestion what will happen to the users experience?

PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …

Why do my calls to the PCoIP Agent WMI counters return 0 values?

Problem All calls to WMI counters (i.e. PCoIP Session Log and Statistics Viewer ) return 0 values. Cause By default, 32 bit applications accessing WMI gets a handle to a 32 bit WMI provider, and 64 bit applications accessing WMI get a handle to a 64 bit …

When are PCoIP session statistics reset on a PCoIP Zero Client?

Session statistics are reset at the start of each PCoIP session, i.e. when a session is connected. You can also reset them during a session through the AWI under Diagnostics, Session Statistics, Reset Statistics. … When are PCoIP session statistics …

Unable to start docker containers connector_cm and connector_connectorgateway during HP Anyware Connector installation

In Ubuntu 18.04.4 LTS or Ubuntu 18.04.5 LTS setting up HP Anyware Connector, if IPV6 was disabled in the vm those 2 containers will always fail to start. During the installation or reinstallation of the HP Anyware Connector, connector_cm and …

Can I use Cisco Express Forwarding per-packet load sharing with PCoIP Protocol?

No, Cisco Express Forwarding (CEF) per-packet load sharing causes out-of-order packets which is not compatible with real-time protocols such as PCoIP Protocol. Cisco has similar recommendations against CEF per-packet load sharing when using Voice-over-IP …

Does the PCoIP Management Console 2.x and 3.x ship with a default certificate?

Yes. The PCoIP Management Console since release 2.x ships with a HP Anyware self-signed certificate to allow the PCoIP Management Console to function out of the box. It is recommended that all users deploying the PCoIP Management Console 2.x or …

Does the TERA2321 support the SGMII interface for a copper SFP?

Answer: No. The Tera2321 only supports MII (10/100Mbps) or RGMII (10/100/1000Mbps) copper/fiber interfaces. Definitions : SGMII - Serial Gigabit Media Independent Interface. RGMII - Reduced Gigabit Media Independent Interface. MII - Media Independent …

Can I add software to or change the operating system of a PCoIP Zero Client?

PCoIP Zero Clients do not run local application software. They run secure custom firmware created by HP Anyware only. This makes them extremely secure PCoIP Clients allowing for simple management and updates through small firmware updates. New features …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: September 22, 2023

239

Random individual and mass client disconnects due to Cisco VSS Inter-switch links

Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops. Cause There have been observed …

What are the priorities for video, audio, and USB PCoIP traffic?

PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics