Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Troubleshooting artifacts in a PCoIP Session

Problem During a PCoIP Session artifacts are appearing on the screen. The artifacts may stay or slowly disappear. Cause and Resolution There are may reasons artifacts may appear on the screen. Some may be source issues such as the application or …

How do I configure my 4 monitors in the PCoIP Zero Client OSD?

To configure 4 monitors to your preference, follow the steps below. Before you begin, make sure that you know what monitor is connected to what PCoIP Zero Client port number. From the onscreen display (OSD) of your PCoIP Zero Client, browse to Options > …

Display resolution, topology, image artifacts or rendering-performance issues in HP Anyware with a GPU

Symptoms If you are using HP Anyware's Graphics agents with a GPU, either Nvidia GRID or AMD FirePro, the following issues may be caused by incorrect GPU driver: Image tearing Image artifacts Slow connection times Display topology issues Low frame rates …

Do PCoIP Zero Clients support single and multi-touch monitors?

Answer: PCoIP Zero Clients support selected ELO touch monitors in pre-session (using the Teradici OSD) since Firmware 3.4.0,and should support other touchscreen monitors (single and multi-touch) while in a PCoIP session. To make a connection using a …

Knowledge Base Article Advisory Display Zero Clients

Last modified: September 21, 2023

1480

The Mouse and Keyboard are not working with the HP Anyware PCoIP Linux Agent

Problem When connecting to a Linux desktop running the HP Anyware PCoiP Agent for Linux Standard or Graphics, you have no keyboard or mouse input but your desktop shows. Cause There are two main reasons why this can happen: The display topology between …

Why is the BIOS not visible when my Dell workstation boots with a PCoIP Remote Workstation Card?

Scenario The BIOS on a Dell R5500/R5400 is not visible on boot up. After the OS loads, the monitor then displays the desktop. On some graphic cards, only the primary port is active during the POST phase of the host PC boot process. For example, when using …

Why PCoIP Zero Clients cannot operate at USB 2.0 speeds of 480Mbits/s?

The most common cause of slow USB data transfers is related to the network environment.USB data transfers are sensitive to the available network bandwidth, latency, and packet loss. Following are the few reasons that can cause the reduction in …

What USB CD/DVD drives should I consider using with PCoIP Zero Clients?

Teradici does not maintain a list of tested units. With the introduction of EHCI (USB 2) functionality, compatibility with currently manufactured DVD brands has improved greatly, particularly when the PCoIP Zero Client or PCoIP Remote Workstation Card …

Why is the BIOS not accessible from my PCoIP Workstation solution?

The BIOS must be able to enumerate the PCIe PCoIP Remote Workstation Card and support OHCI which typically does not occur until post BIOS. USB peripherals (keyboard, mouse etc.) connected to PCIe PCoIP Remote Workstation Cards as in a PCoIP Workstation …

USB Network Hub Option for High-Speed USB 2.0 Peripherals

Scenario Tera1 PCoIP Zero Clients with firmware 3.5.0 or newer supports up to 3x the USB transfer rate of previous firmware builds. If additional USB bandwidth is required then consider: Using Tera2 based PCoIP Zero Clients Using an external USB network …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics