What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
Knowledge Base Article Troubleshooting Display HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3523
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3283
How can I shadow a VMware Horizon View PCoIP desktop session from my vSphere console?
Note: This knowledge base article does not apply to HP Anyware. HP Anyware uses a  Anyware software GPU or a hardware GPU disabling the vSphere Console. In some cases viewing a remote users PCoIP session may be beneficial to troubleshooting an issue. In …
Knowledge Base Article Tutorial Setup Display Third Party Enhancements Zero Clients
Last modified: September 3, 2023
3134
Why does the "USB device not authorized"message appear on my display?
This message indicates that an unauthorized USB device is attached to the PCoIP Zero Client. Be sure allowed USB devices are specified in the list of authorized devices and not in the list of unauthorized devices in the USB page of the PCoIP Zero Client's …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: September 3, 2023
2885
Why do I get a gray screen when connecting from the HP Anyware PCoIP Software Client to a PCoIP Remote Workstation Card?
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …
Knowledge Base Article Troubleshooting Display Remote Workstation Card
Last modified: September 3, 2023
2706
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2491