How can I tell which monitors are connected and if a USB device is connected locally or bridged on a PCoIP Zero Client?
Answer: From your Web browser, enter the IP address of your PCoIP Zero Client. Log in to the user interface with your user credentials. (Note: Depending on your specific setup, a password may not be required.) From the Info menu, select Attached Devices . …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: October 31, 2022
252
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 18, 2022
247
Does the PCoIP Zero Client have left hand mouse configuration settings?
The PCoIP Zero Client currently has no specific left hand mouse setting. The PCoIP Zero Client configuration options in the OSD were designed to negate the necessity for right hand or left hand functionality therefore both buttons act the same. Right hand …
Knowledge Base Article Advisory Peripheral Devices Zero Clients
Last modified: September 3, 2023
223
What are the priorities for video, audio, and USB PCoIP traffic?
PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …
Knowledge Base Article Advisory Performance Peripheral Devices HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
224
How do I make PCoIP Remote Workstation Card USB devices work on my Fujitsu CELSIUS R930 workstation?
Answer: If USB devices won't work on a R930, move the PCoIP Remote Workstation Card to a PCIe slot that is serviced by a populated CPU socket. Why this is necessary: The R930 has two sockets. If the unit ships with only one socket populated (a single …
Knowledge Base Article Troubleshooting Setup Peripheral Devices Remote Workstation Card
Last modified: September 3, 2023
215
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
211