Why is the network connection lost when a USB disk is plugged into a PCoIP Zero Client?
Scenario A desktop freeze, session disconnect or "network connection lost" (if the overlay network error message is enabled) message is displayed after an USB disk is plugged into a PCoIP Zero Client.   Cause A heavy load such as autoplay on a flash drive …
Knowledge Base Article Tutorial Peripheral Devices Zero Clients
Last modified: November 24, 2022
481
No audio when using Unified Communications with a USB headset
Problem Some users have reported no audio when using Unified Communications solution in firmware 4.7.0, they can only hear the ring of the incoming call and when the call is answered there is no Rx/Tx audio.   Cause This issue has been tracked down to the …
Knowledge Base Article Troubleshooting Performance Peripheral Devices Zero Clients
Last modified: November 7, 2022
463
When does the PCoIP Management Console apply a resolution change using the Enable Preferred Resolution Override setting while in a PCoIP session?
In PCoIP Management Console (MC) 1.9.1 (and newer), PCoIP Zero Clients with firmware 4.1.2 (and newer) can be configured to override the attached monitors native resolution using the Enable Preferred Resolution Override feature. The setting is recognized …
Knowledge Base Article Troubleshooting Management Display Management Console Zero Clients
Last modified: September 3, 2023
451
What are the cabling requirements in a Remote Workstation Card environment?
Answer: HP Anyware PCoIP Remote Workstation Cards and PCoIP Zero Clients are designed considering port pass through and should be connected in a specific manner to limit potential display issues. In a PCoIP workstation environment ensure the connection …
Knowledge Base Article Advisory Display Remote Workstation Card
Last modified: August 2, 2023
442
MagTek USB Keyboard Emulation Card Swipe Reader (i.e. credit card reader) causes "stuck key" problem
Scenario Occasionally when using a MagTek USB KB Swipe Card Reader attached to a zero client, the card data is read incorrectly. This can cause undefined behaviour. (i.e. a key repeats indefinitely).   Cause Some USB Keyboard Emulation Card Readers have …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: November 7, 2022
441
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
Knowledge Base Article Troubleshooting Display Performance Zero Clients HP Anyware
Last modified: August 2, 2023
430
What types of USB devices are supported in Linux with the PCoIP Remote Workstation Card?
The Tera2 PCoIP Remote Workstation Card presents a Open Host Controller Interface (OHCI) and Enhanced Host Controller Interface (EHCI), supporting the USB 1.0 and USB 2.0 specifications respectively, via the PCIe 1x connector to the motherboard. If is up …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card
Last modified: August 2, 2023
384
Why can I use my cell phone to transfer files when I have blocked all mass storage devices through the Unauthorized Devices table?
There are 3 ways to transfer data to USB devices. Mass storage devices (flash drives, DVD), all file types Photo Transfer Protocol - PTP - still image capture device class for cameras, (pictures). Media Transport Protocol - MTP - (smartphones), all file …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: November 17, 2022
374