MagTek USB Keyboard Emulation Card Swipe Reader (i.e. credit card reader) causes "stuck key" problem
Scenario Occasionally when using a MagTek USB KB Swipe Card Reader attached to a zero client, the card data is read incorrectly. This can cause undefined behaviour. (i.e. a key repeats indefinitely).   Cause Some USB Keyboard Emulation Card Readers have …
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
What types of USB devices are supported in Linux with the PCoIP Remote Workstation Card?
The Tera2 PCoIP Remote Workstation Card presents a Open Host Controller Interface (OHCI) and Enhanced Host Controller Interface (EHCI), supporting the USB 1.0 and USB 2.0 specifications respectively, via the PCIe 1x connector to the motherboard. If is up …
Why can I use my cell phone to transfer files when I have blocked all mass storage devices through the Unauthorized Devices table?
There are 3 ways to transfer data to USB devices. Mass storage devices (flash drives, DVD), all file types Photo Transfer Protocol - PTP - still image capture device class for cameras, (pictures). Media Transport Protocol - MTP - (smartphones), all file …
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Is the current Texas Instruments USB to serial adapter in the Samsung NC241 compatible with View 5.0?
Answer: No, the current Texas Instruments USB to serial adapter built in to the Samsung NC241 is not compatible with View 5.0, or with the latest TI drivers. For View 5.0 an older legacy driver must be used. This driver must be obtained directly from …
Why do I see black bars on the side or bottom of my display when connecting to a zero client?
Scenario : When connecting a display (TV or monitor) to a PCoIP zero client you get solid black bars at the top and bottom or left and right sides of the display. It appears as if the image is being cut off. Resolution : This issue is caused by ' …