Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
Knowledge Base Article Tutorial Performance Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
5177
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4876
Host Display Health Check - Diagnostics and troubleshooting guide
Summary To receive a detailed host diagnostic report, create a host agent  support/log file bundle  and then submit this bundle to the PCoIP  health check   tool.  Once the files are submitted, it will take 5-10 minutes to produce a detailed report.  The …
Knowledge Base Article Diagnostics Display HP Anyware Remote Workstation Card
Last modified: September 3, 2023
4090
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …
Knowledge Base Article Tutorial Setup Display Zero Clients
Last modified: September 3, 2023
4094
How do I determine how much bandwidth a PCoIP Protocol Session is consuming?
There are multiple options to determine how much bandwidth a PCoIP protocol session is consuming.   Viewing live data on a PCoIP Zero Client or PCoIP Remote Workstation Card The active PCoIP protocol session bandwidth can be viewed in the PCoIP Zero …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card
Last modified: September 3, 2023
4064
Troubleshooting Video Playback Issues ?
There are many factors impacting the playback of video in a PCoIP environment. Factors that influence video playback are: PCoIP Thin Client or Software Client local hardware capabilities. PCoIP can require a lot of processing power not available on …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4045
PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
Knowledge Base Article Troubleshooting Performance Display Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
3803
What does the yellow marker mean on the top right of the screen when using the PCoIP Graphics Agent?
Problem During a PCoIP session there is a yellow marker on the top right of one or more displays. The yellow marker indicates that the PCoIP Graphics Agent is experiencing issues with the GPU configuration and has fallen back to non-accelerated …
Knowledge Base Article Troubleshooting Display HP Anyware
Last modified: September 3, 2023
3575
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3525