Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Getting blank screen or "source signal on other port" when connecting from zero client to VMware Horizon
Scenario: When using a PCoIP zero client connecting to VMware VM running Horizon Agent 8.2 if the VMware remote console is open while user is in session the zero client will display a blank screen or you may receive a message "source signal on other …
How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?
Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …
How to configure an Amazon Network Load Balancer (NLB) with the PCoIP Connection Manager and Security Gateway or HP Anyware Connector
The following article provides an example on how to  setup an Amazon Network Load Balancer with the PCoIP Connection Manager and Security Gateway (CM/SG) or HP Anyware Connector (CAC). Prerequisites:   Connection Manager & Security Gateway: 1. Deploy the …
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
How do I disable login username caching on a PCoIP Zero Client?
On a PCoIP Zero Client, username caching is set in the advanced options and can be disabled from the OSD Screen, the Administrative Web Interface (AWI), or the PCoIP Management Console.    From the OSD Screen: Under Options, select Configuration In the …