Troubleshooting out of order packets impacting the PCoIP protocol?
Problem The PCoIP session performance is poor. The logs indicate high packet loss and the error messages related to out of order packets. Note:The default PCoIP server logs will indicate when out of order mode is activated and deactivated. To see …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
5786
How do I check for packet loss on the ESX interface?
If there is packet loss on a PCoIP protocol session, but an analysis of network devices in the path show no loss and they have been properly configured (see  Network session checklist for PCoIP protocol LAN and WAN deployments ) then you may want to …
Knowledge Base Article Tutorial Performance Third Party Enhancements Remote Workstation Card
Last modified: September 3, 2023
5684
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
Knowledge Base Article Tutorial Performance Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
5183
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4886
Host Display Health Check - Diagnostics and troubleshooting guide
Summary To receive a detailed host diagnostic report, create a host agent  support/log file bundle  and then submit this bundle to the PCoIP  health check   tool.  Once the files are submitted, it will take 5-10 minutes to produce a detailed report.  The …
Knowledge Base Article Diagnostics Display HP Anyware Remote Workstation Card
Last modified: September 3, 2023
4136
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …
Knowledge Base Article Tutorial Setup Display Zero Clients
Last modified: September 3, 2023
4120