No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
274
Error: PCoIP Agent has no available licenses to launch the remote session
Symptom Remote desktops that were previously registered with HP Anyware Cloud License Server (CLS) may get the following client message when trying to connect: “Error – PCoIP Agent has no available licenses to launch the remote session.” In the Anyware …
Knowledge Base Article Advisory Troubleshooting Licensing HP Anyware
Last modified: September 3, 2023
273
How can I tell if the 802.1x certificate uploaded successfully?
A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …
Knowledge Base Article Tutorial Security Remote Workstation Card Zero Clients
Last modified: August 23, 2018
269
How can I tell which monitors are connected and if a USB device is connected locally or bridged on a PCoIP Zero Client?
Answer: From your Web browser, enter the IP address of your PCoIP Zero Client. Log in to the user interface with your user credentials. (Note: Depending on your specific setup, a password may not be required.) From the Info menu, select Attached Devices . …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: October 31, 2022
257
Why do certain large screen (>27" monitors) dual-link DVI monitors not work with the TERA 2 PCoIP Zero Clients?
Scenario When some monitors supporting 2560 x 1600 and 2560 x 1440 resolutions are power cycled with the power switch, the video may not appear when connected to a Tera2 Zero Client via dual-link DVI. This applies to: Tera2 Zero Clients running firmware …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 18, 2022
248
Local Administrative Password setting is disabled after changing the firmware version in the profile in the PCoIP Management Console 3.0.0
Problem After changing the firmware version in a profile in PCoIP Management Console 3.0.0 the Local Administrative Password setting is no longer enabled and the password field is blank.   Cause This issue is known to happen when the following conditions …
Knowledge Base Article Troubleshooting Security Management Management Console
Last modified: November 7, 2022
219
Recovering the OSD when the resolution was set to 800x600 or lower which removed functionality.
This occurs because these low resolutions do not display the OSD correctly, and access to some configurations are lost. Previously this was not an available feature which prevented devices being put into un-configurable states by setting resolutions to …
Knowledge Base Article Troubleshooting Display Management Console Zero Clients
Last modified: September 3, 2023
212