Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

The PCoIP protocol determines the bandwidth limit by examining network conditions such as received bandwidth, latency, and packet loss. The PCoIP protocol adapts to provide the best user experience for the available bandwidth. When congestion is …

Default HP Anyware Connector docker network conflicts with VPN network

Scenario: The default HP Anyware Connector docker network is conflicting with VPN network. When specifying the --connector-network-cidr flag during the installation of HP Anyware Connector the docker network is that same range as the default 172.x How can …

Does PCoIP Protocol support half duplex networking equipment?

PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …

Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?

Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …

How do I configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card?

There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card. Option 1: Use the PC NIC and PCoIP Host Software For instructions, refer to How do I remotely power on the host PC/workstation through its network interface …

When the network experiences periods of high congestion what will happen to the users experience?

PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …

Why do my calls to the PCoIP Agent WMI counters return 0 values?

Problem All calls to WMI counters (i.e. PCoIP Session Log and Statistics Viewer ) return 0 values. Cause By default, 32 bit applications accessing WMI gets a handle to a 32 bit WMI provider, and 64 bit applications accessing WMI get a handle to a 64 bit …

When are PCoIP session statistics reset on a PCoIP Zero Client?

Session statistics are reset at the start of each PCoIP session, i.e. when a session is connected. You can also reset them during a session through the AWI under Diagnostics, Session Statistics, Reset Statistics. … When are PCoIP session statistics …

Can I add software to or change the operating system of a PCoIP Zero Client?

PCoIP Zero Clients do not run local application software. They run secure custom firmware created by HP Anyware only. This makes them extremely secure PCoIP Clients allowing for simple management and updates through small firmware updates. New features …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: September 22, 2023

249

Does the TERA2321 support the SGMII interface for a copper SFP?

Answer: No. The Tera2321 only supports MII (10/100Mbps) or RGMII (10/100/1000Mbps) copper/fiber interfaces. Definitions : SGMII - Serial Gigabit Media Independent Interface. RGMII - Reduced Gigabit Media Independent Interface. MII - Media Independent …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics