What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3539
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3302
How can I shadow a VMware Horizon View PCoIP desktop session from my vSphere console?
Note: This knowledge base article does not apply to HP Anyware. HP Anyware uses a  Anyware software GPU or a hardware GPU disabling the vSphere Console. In some cases viewing a remote users PCoIP session may be beneficial to troubleshooting an issue. In …
Knowledge Base Article Tutorial Setup Display Third Party Enhancements Zero Clients
Last modified: September 3, 2023
3148
Authentication failures with my eToken/smartcard device and VMware Horizon
Prerequisites eToken devices work based on the scenario in which they are intended to be used and the proper installation of the PCoIP Smartcard feature. Three scenario's are described below after the PCoIP Smartcard installation: PCoIP Smartcard …
Knowledge Base Article Troubleshooting Authentication Security Third Party Enhancements Zero Clients
Last modified: September 14, 2023
2842
Why do I get a gray screen when connecting from the HP Anyware PCoIP Software Client to a PCoIP Remote Workstation Card?
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …
Knowledge Base Article Troubleshooting Display Remote Workstation Card
Last modified: September 3, 2023
2718
Why does my pre-session smart card authentication fail with my PCoIP Zero Client but not my VMware Horizon client?
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …
Knowledge Base Article Advisory Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
2596
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2499
MFA (Multi Factor Authentication) options are not being displayed on the PCoIP Zero Client when authenticating to a VMware Horizon View Connection Server
Problem MFA (Multi Factor Authentication) options are not being displayed on the PCoIP Zero Client when authenticating to a VMware Horizon View Connection Server. The MFA challenge is only showing a short prompt regardless of which option you have …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: November 24, 2023
2497