Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
257
When the network experiences periods of high congestion what will happen to the users experience?
PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …
Knowledge Base Article Tutorial Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: December 9, 2022
252
Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
231
What are the priorities for video, audio, and USB PCoIP traffic?
PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …
Knowledge Base Article Advisory Performance Peripheral Devices HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
222
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Knowledge Base Article Advisory Performance Display Remote Workstation Card Zero Clients
Last modified: July 3, 2020
208
How does PCoIP handle networks with high traffic volumes?
When you plan to use PCoIP on network with high volumes of other traffic that may cause congestion, it is recommended that QoS is implemented to give PCoIP guaranteed bandwidth. PCoIP will adjust to use it's fair share of the network but UDP is typically …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
209
What is Intelligent Packet Re-Transmission in PCoIP Protocol?
PCoIP Protocol uses UDP protocol similar to other real-time protocols (voice-over-IP, interactive video conferencing etc).  This is done to minimize the overhead associated with TCP protocol.  However, reliable transmission of data is important for remote …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
205
Can I constrain PCoIP bandwidth usage to fit my network?
The maximum PCoIP bandwidth usage an be configured per a session. When restricting the maximum PCoIP session bandwidth, the frame rate and image quality maybe reduced due to the reduction in bandwidth. For limiting PCoIP Zero Clients see: PCoIP Zero …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
200