PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
Knowledge Base Article Troubleshooting Performance Display Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
3848
What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3711
How can I shadow a VMware Horizon View PCoIP desktop session from my vSphere console?
Note: This knowledge base article does not apply to HP Anyware. HP Anyware uses a  Anyware software GPU or a hardware GPU disabling the vSphere Console. In some cases viewing a remote users PCoIP session may be beneficial to troubleshooting an issue. In …
Knowledge Base Article Tutorial Setup Display Third Party Enhancements Zero Clients
Last modified: September 3, 2023
3164
How do I Set Zero Client password in PCoIP Management Console?
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
Knowledge Base Article Tutorial Authentication Management Management Console Zero Clients
Last modified: September 3, 2023
3099
Why does the "USB device not authorized"message appear on my display?
This message indicates that an unauthorized USB device is attached to the PCoIP Zero Client. Be sure allowed USB devices are specified in the list of authorized devices and not in the list of unauthorized devices in the USB page of the PCoIP Zero Client's …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: September 3, 2023
2930
Authentication failures with my eToken/smartcard device and VMware Horizon
Prerequisites eToken devices work based on the scenario in which they are intended to be used and the proper installation of the PCoIP Smartcard feature. Three scenario's are described below after the PCoIP Smartcard installation: PCoIP Smartcard …
Knowledge Base Article Troubleshooting Authentication Security Third Party Enhancements Zero Clients
Last modified: September 14, 2023
2863
What is an acceptable level of packet loss?
Just like VoIP and video conferencing, PCoIP is a real time protocol. Once a packet is lost in transit, there typically isn't time to re transmit before the PCoIP session is impacted. Therefore, the most acceptable level of loss is 0%. Packet loss maybe …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2753
Do PCoIP Zero Clients support multi-factor authentication?
PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …
Knowledge Base Article Advisory Authentication Security HP Anyware Zero Clients
Last modified: September 21, 2023
2639
Why does my pre-session smart card authentication fail with my PCoIP Zero Client but not my VMware Horizon client?
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …
Knowledge Base Article Advisory Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
2614