No warning message when VMware View Connection Server Certificate Check Mode is set to Warn if Connection may be insecure (Default)
This is expected behavior. Configured non-interactive session modes do not display VCS Warning messages in Warn if the connection may be insecure (Default) security mode.  Interactive session modes will display VCS Error messages in Warn if the connection …
Knowledge Base Article Troubleshooting Security Third Party Enhancements Zero Clients
Last modified: September 3, 2023
272
Does PCoIP Protocol support half duplex networking equipment?
PCoIP protocol does not support half-duplex network equipment. If a half-duplex equipment is connected to a PCoIP Remote Workstation Card or PCoIP Zero Client, the following message shows in the Event Log. 0d,00:04:05.710> Network link rate: 10 Mbit/s, …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients
Last modified: July 3, 2020
263
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Knowledge Base Article Troubleshooting Setup Performance Third Party Enhancements Remote Workstation Card Zero Clients
Last modified: September 20, 2023
258
In VMware Horizon View, what does it mean when a particular USB issue happens on both the VMware View client and the PCoIP Zero Client?
Answer: If a USB peripheral has the same issue on both PCoIP Zero Clients and VMware View clients (repurposed PC, notebook or thin client running the View Client), it's likely that the issue is in the VMware virtual USB hub driver, or is an issue with …
Knowledge Base Article Troubleshooting Peripheral Devices Third Party Enhancements Zero Clients
Last modified: September 3, 2023
255
When the network experiences periods of high congestion what will happen to the users experience?
PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …
Knowledge Base Article Tutorial Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: December 9, 2022
253
Random individual and mass client disconnects due to Cisco VSS Inter-switch links
Problem Random individual client disconnect, or mass client disconnects when connecting clients (PCoIP Software Clients, VMware View Clients, or PCoIP Zero Clients) connected to HP Anyware or VMware View virtual desktops.   Cause There have been observed …
Knowledge Base Article Troubleshooting Session Performance Zero Clients
Last modified: August 7, 2023
232
What are the priorities for video, audio, and USB PCoIP traffic?
PCoIP technology gives priority to USB and audio, while imaging uses remaining available bandwidth. PCoIP technology optimizes user experience for a given bandwidth by adaptively controlling quality and update rate of the image data, and optionally …
Knowledge Base Article Advisory Performance Peripheral Devices HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
226
How does PCoIP handle networks with high traffic volumes?
When you plan to use PCoIP on network with high volumes of other traffic that may cause congestion, it is recommended that QoS is implemented to give PCoIP guaranteed bandwidth. PCoIP will adjust to use it's fair share of the network but UDP is typically …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
210