Tera 2 PCoIP Zero Client and PCoIP Remote Workstation Card firmware prerequisites when upgrading to new firmware releases.
Answer Depending on the currently installed firmware version on your Tera2 device, an upgrade to new firmware may require an intermediate firmware upload. To upgrade the PCoIP Zero Client and PCoIP Remote Workstation Card firmware, follow the associated …
How do I upload firmware on PCoIP Zero Clients or PCoIP Remote Workstation Card?
This knowledge base article applies to using the Administrative Web Interface (AWI) as the tool used to upload firmware. To upload the firmware using the PCoIP Management Console, refer to Management Console 202x.x (or 1.10.x) administrators' guide and …
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
How can I change USB authorizations for PCoIP Zero Client?
USB devices can be enabled or disabled which allows IT control of the use of peripherals with HP Anyware PCoIP Agent, VMware Horizon View using PCoIP protocol, or PCoIP Remote Workstation Cards. PCoIP Zero Clients provide unique USB security features that …
How do I Set Zero Client password in PCoIP Management Console?
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
Authentication failures with my eToken/smartcard device and VMware Horizon
Prerequisites eToken devices work based on the scenario in which they are intended to be used and the proper installation of the PCoIP Smartcard feature. Three scenario's are described below after the PCoIP Smartcard installation: PCoIP Smartcard …
Do PCoIP Zero Clients support multi-factor authentication?
PCoIP Zero Clients support multi-factor authentication when connecting to HP Anyware, PCoIP Remote Workstation Cards, VMware or Amazon WorkSpaces. These can be used in pre-session authentication and in-session/post-session authentication scenarios. Since …
What are the requirements to support pre-session smart card authentication when connecting to VMware Horizon (View)?
Note: With the release of PCoIP Zero Client firmware 6.1.0, the information in the knowledge base article has been moved into the PCoIP Zero Client Administrators' guide to ensure the list is current at the time of each firmware release. See PCoIP Zero …