Tera 2 PCoIP Zero Client and PCoIP Remote Workstation Card firmware prerequisites when upgrading to new firmware releases.
Answer Depending on the currently installed firmware version on your Tera2 device, an upgrade to new firmware may require an intermediate firmware upload. To upgrade the PCoIP Zero Client and PCoIP Remote Workstation Card firmware, follow the associated …
How do I upload firmware on PCoIP Zero Clients or PCoIP Remote Workstation Card?
This knowledge base article applies to using the Administrative Web Interface (AWI) as the tool used to upload firmware. To upload the firmware using the PCoIP Management Console, refer to Management Console 202x.x (or 1.10.x) administrators' guide and …
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
How can I change USB authorizations for PCoIP Zero Client?
USB devices can be enabled or disabled which allows IT control of the use of peripherals with HP Anyware PCoIP Agent, VMware Horizon View using PCoIP protocol, or PCoIP Remote Workstation Cards. PCoIP Zero Clients provide unique USB security features that …
How do I Set Zero Client password in PCoIP Management Console?
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
How do I enable NTP on PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Enabling NTP is important on the PCoIP Zero Client and PCoIP Remote Workstation Card. NTP is using for the following: Setting the time and date of the PCoIP Zero Client and PCoIP Remote Workstation Card. As there is no battery on the devices, the time and …
How do I enable and disable the PCoIP Zero Client session disconnect CTRL-ALT-F12 key sequence?
Enable When using a PCoIP Zero Client to connect to HP Anyware, Amazon Workspaces or VMware Horizon View the Ctrl-Alt-F12 shortcut is enabled by default. This setting can be configured via the AWI or PCoIP Management Console. When using a workstation with …
How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?
Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …
Determining why the PCoIP Zero Client was reset to factory default
Problem The PCoIP Zero Client unexpectedly reset to factory default.    Cause The PCoIP Zero Client would only reset to factory defaults if one of the reset options was used. The PCoIP Zero Client can be reset by the PCoIP Management Console, through the …