Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

How do I enable and disable the PCoIP Zero Client session disconnect CTRL-ALT-F12 key sequence?

Enable When using a PCoIP Zero Client to connect to HP Anyware, Amazon Workspaces or VMware Horizon View the Ctrl-Alt-F12 shortcut is enabled by default. This setting can be configured via the AWI or PCoIP Management Console. When using a workstation with …

How do I gather PCoIP client logs for the HP t410 (and change its logging verbosity)?

The HP t410 Smart Zero Client uses Teradici's PCoIP software. The PCoIP client logs are accessible on a HP t410 client through the on-screen-display. A bundle of log files can be saved to a local USB flash drive connected to the t410 client using the …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: July 27, 2023

1691

How to change the Num Lock setting on a PCoIP Zero Client

The num lock ( numlock) setting depends on whether the PCoIP Zero Client is at the On-Screen-Display (OSD) or when in-session. On-Screen-Display operation The "Factory" default setting of num lock can be set by the PCoIP Zero Client OEM during …

Workstation Remote Power Off

Remote power On Tera2 based PCoIP Zero Clients, the remote power off function can be access by pushing the power button briefly. This will bring up an on screen menu that can be cycled via the power button. The only power function available is Workstation …

How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?

Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …

What is the impact of power outage during firmware update?

Firmware 5.0.0 and newer Due to additional functionality added to the PCoIP Zero Client over time, there is no longer space for two complete firmware images. To prevent the PCoIP Zero Client from entering an unrecoverable state from a power outage during …

Knowledge Base Article Advisory Setup Zero Clients

Last modified: November 16, 2022

1629

How do I configure my 4 monitors in the PCoIP Zero Client OSD?

To configure 4 monitors to your preference, follow the steps below. Before you begin, make sure that you know what monitor is connected to what PCoIP Zero Client port number. From the onscreen display (OSD) of your PCoIP Zero Client, browse to Options > …

Why PCoIP Zero Clients cannot operate at USB 2.0 speeds of 480Mbits/s?

The most common cause of slow USB data transfers is related to the network environment.USB data transfers are sensitive to the available network bandwidth, latency, and packet loss. Following are the few reasons that can cause the reduction in …

What are the DNS SRV records supported by PCoIP Zero Client and PCoIP Remote Workstation Card firmware?

There are four different DNS SRV records that are supported in firmware. pcoip-bootstrap (PCoIP Management Console 2.x and newer, Firmware 5.x and newer) - The firmware uses this DNS SRV record along with other records to complete the bootstrap process …

What USB CD/DVD drives should I consider using with PCoIP Zero Clients?

Teradici does not maintain a list of tested units. With the introduction of EHCI (USB 2) functionality, compatibility with currently manufactured DVD brands has improved greatly, particularly when the PCoIP Zero Client or PCoIP Remote Workstation Card …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics