How do I find the IP address of my newly installed PCoIP Zero Client or PCoIP Remote Workstation card?
Answer: You can determine the IP address associated with your device using one of the following methods: Before you begin, write down the MAC address of the device you want to determine the IP address of. For most of these methods, the MAC address is …
With All Access, is there still a free option for PCoIP Zero Client firmware and PCoIP Management Console?
Yes,  HP Anyware does offer the ability to trial free of charge, the Zero client firmware and the Management Console.  Once a trial is complete, the Management Console will still be able to be used to manual management of up to 100 endpoints. Subscription …
Configuration of smart cards with PCoIP Zero Clients and VMWare Horizon
This article is provided to help administrators in setting up smart card authentication in zero clients connecting to VMWare Horizon. This article has been reviewed against the following supported hardware and software versions: VMware Horizon 7.2 PCoIP …
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …