How to use the HP Anyware Licensing Portal
The HP Anyware Licensing Portal provides secure access to the list of licenses and can be used by the company's assigned Account Administrator. The Account Administrator role can be fulfilled by one central administrator or can be distributed across …
Cannot connect to session: Client shows licensing-related errors, or error 0x1002
Problem When attempting to establish a remote connection using a PCoIP client, the connection fails and one of these error messages appears: PCoIP Agent has no available licenses to launch the remote session. Please try again later. This desktop has no …
Tera 2 PCoIP Zero Client and PCoIP Remote Workstation Card firmware prerequisites when upgrading to new firmware releases.
Answer Depending on the currently installed firmware version on your Tera2 device, an upgrade to new firmware may require an intermediate firmware upload. To upgrade the PCoIP Zero Client and PCoIP Remote Workstation Card firmware, follow the associated …
Why can't I change the display resolution in Windows when using HP Anyware on Windows?
Problem When connected to a remote machine via HP Anyware on Windows, opening the display settings results in greyed out options and a message "Some settings are controlled by your system administrator". You cannot change the screen resolution, select the …
How do I upload firmware on PCoIP Zero Clients or PCoIP Remote Workstation Card?
This knowledge base article applies to using the Administrative Web Interface (AWI) as the tool used to upload firmware. To upload the firmware using the PCoIP Management Console, refer to Management Console 202x.x (or 1.10.x) administrators' guide and …
Why has my PCoIP Client display temporarily shown a black screen?
Scenario While in a PCoIP session, the display(s) temporarily go black for a few seconds (typically 1-5 seconds) and then resumes normal operation. Occasionally the screen may be briefly frozen instead of turning black.   Cause This entry signifies that …
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …