Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Authentication failures with my eToken/smartcard device and VMware Horizon
Prerequisites eToken devices work based on the scenario in which they are intended to be used and the proper installation of the PCoIP Smartcard feature. Three scenario's are described below after the PCoIP Smartcard installation: PCoIP Smartcard …
Why does my pre-session smart card authentication fail with my PCoIP Zero Client but not my VMware Horizon client?
Problem You cannot establish a PCoIP session using your smart card in pre-session with a PCoIP Zero Client, but you are successful when using a VMware Horizon client. Note: Make sure that your smartcard and smartcard reader meet the requirements listed …
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …
MFA (Multi Factor Authentication) options are not being displayed on the PCoIP Zero Client when authenticating to a VMware Horizon View Connection Server
Problem MFA (Multi Factor Authentication) options are not being displayed on the PCoIP Zero Client when authenticating to a VMware Horizon View Connection Server. The MFA challenge is only showing a short prompt regardless of which option you have …
Tera 1 PCoIP Zero Client or PCoIP Remote Workstation card firmware prerequisites when upgrading to new firmware releases.
Answer: Note: HP Anyware Tera 1 PCoIP Zero Client devices and firmware are End of Life. Whist Tera 1 based PCoIP Zero Clients can be upgraded to Firmware 4.7.1 they lack many of the modern security standards for network communication. It is recommended …
What are the requirements to support pre-session smart card authentication when connecting to VMware Horizon (View)?
Note: With the release of PCoIP Zero Client firmware 6.1.0, the information in the knowledge base article has been moved into the PCoIP Zero Client Administrators' guide to ensure the list is current at the time of each firmware release. See PCoIP Zero …
What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …