Why is the network connection lost when a USB disk is plugged into a PCoIP Zero Client?
Scenario A desktop freeze, session disconnect or "network connection lost" (if the overlay network error message is enabled) message is displayed after an USB disk is plugged into a PCoIP Zero Client.   Cause A heavy load such as autoplay on a flash drive …
Knowledge Base Article Tutorial Peripheral Devices Zero Clients
Last modified: November 24, 2022
498
No audio when using Unified Communications with a USB headset
Problem Some users have reported no audio when using Unified Communications solution in firmware 4.7.0, they can only hear the ring of the incoming call and when the call is answered there is no Rx/Tx audio.   Cause This issue has been tracked down to the …
Knowledge Base Article Troubleshooting Performance Peripheral Devices Zero Clients
Last modified: November 7, 2022
476
When does the PCoIP Management Console apply a resolution change using the Enable Preferred Resolution Override setting while in a PCoIP session?
In PCoIP Management Console (MC) 1.9.1 (and newer), PCoIP Zero Clients with firmware 4.1.2 (and newer) can be configured to override the attached monitors native resolution using the Enable Preferred Resolution Override feature. The setting is recognized …
Knowledge Base Article Troubleshooting Management Display Management Console Zero Clients
Last modified: September 3, 2023
462
MagTek USB Keyboard Emulation Card Swipe Reader (i.e. credit card reader) causes "stuck key" problem
Scenario Occasionally when using a MagTek USB KB Swipe Card Reader attached to a zero client, the card data is read incorrectly. This can cause undefined behaviour. (i.e. a key repeats indefinitely).   Cause Some USB Keyboard Emulation Card Readers have …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: November 7, 2022
451
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
Knowledge Base Article Troubleshooting Display Performance Zero Clients HP Anyware
Last modified: August 2, 2023
447
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
383
Why can I use my cell phone to transfer files when I have blocked all mass storage devices through the Unauthorized Devices table?
There are 3 ways to transfer data to USB devices. Mass storage devices (flash drives, DVD), all file types Photo Transfer Protocol - PTP - still image capture device class for cameras, (pictures). Media Transport Protocol - MTP - (smartphones), all file …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: November 17, 2022
383
Is the current Texas Instruments USB to serial adapter in the Samsung NC241 compatible with View 5.0?
Answer: No, the current Texas Instruments USB to serial adapter built in to the Samsung NC241 is not compatible with View 5.0, or with the latest TI drivers. For View 5.0 an older legacy driver must be used. This driver must be obtained directly from …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: August 1, 2018
361