Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

How do I gather PCoIP client logs for the HP t410 (and change its logging verbosity)?

The HP t410 Smart Zero Client uses Teradici's PCoIP software. The PCoIP client logs are accessible on a HP t410 client through the on-screen-display. A bundle of log files can be saved to a local USB flash drive connected to the t410 client using the …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: July 27, 2023

1692

How to change the Num Lock setting on a PCoIP Zero Client

The num lock ( numlock) setting depends on whether the PCoIP Zero Client is at the On-Screen-Display (OSD) or when in-session. On-Screen-Display operation The "Factory" default setting of num lock can be set by the PCoIP Zero Client OEM during …

Workstation Remote Power Off

Remote power On Tera2 based PCoIP Zero Clients, the remote power off function can be access by pushing the power button briefly. This will bring up an on screen menu that can be cycled via the power button. The only power function available is Workstation …

What is the impact of power outage during firmware update?

Firmware 5.0.0 and newer Due to additional functionality added to the PCoIP Zero Client over time, there is no longer space for two complete firmware images. To prevent the PCoIP Zero Client from entering an unrecoverable state from a power outage during …

Knowledge Base Article Advisory Setup Zero Clients

Last modified: November 16, 2022

1641

How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?

Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …

How do I configure my 4 monitors in the PCoIP Zero Client OSD?

To configure 4 monitors to your preference, follow the steps below. Before you begin, make sure that you know what monitor is connected to what PCoIP Zero Client port number. From the onscreen display (OSD) of your PCoIP Zero Client, browse to Options > …

Troubleshooting artifacts in a PCoIP Session

Problem During a PCoIP Session artifacts are appearing on the screen. The artifacts may stay or slowly disappear. Cause and Resolution There are may reasons artifacts may appear on the screen. Some may be source issues such as the application or …

Do PCoIP Zero Clients support single and multi-touch monitors?

Answer: PCoIP Zero Clients support selected ELO touch monitors in pre-session (using the Teradici OSD) since Firmware 3.4.0,and should support other touchscreen monitors (single and multi-touch) while in a PCoIP session. To make a connection using a …

Knowledge Base Article Advisory Display Zero Clients

Last modified: September 21, 2023

1512

What are the DNS SRV records supported by PCoIP Zero Client and PCoIP Remote Workstation Card firmware?

There are four different DNS SRV records that are supported in firmware. pcoip-bootstrap (PCoIP Management Console 2.x and newer, Firmware 5.x and newer) - The firmware uses this DNS SRV record along with other records to complete the bootstrap process …

How do I identify if enhanced logging is enabled on PCoIP Zero Clients and PCoIP Remote Workstation cards?

Answer: Since firmware 4.0.0, enhanced logging has been identifiable in events logs on PCoIP Zero Clients and PCoIP Remote Workstation Cards (also known as a host card). Event log entries of no module selected indicate enhanced logging is not activated …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics