Why does touchscreen calibration not work with a resolution other then native resolution?
Answer: Calibration for touchscreens via Teradici PCoIP firmware is designed to work from the OSD in native resolution with elo branded touch screens. To calibrate from a different resolution other than native, the elo device must be bridged and the elo …
Knowledge Base Article Advisory Display Zero Clients
Last modified: September 21, 2023
1001
How do I change the image quality properties of a PCoIP Remote Workstation Card?
Review the below table to understand where to change the image quality properties in a remote workstation environment. This information applies to sessions between PCoIP Zero Clients and a PCoIP Remote Workstation Card (i.e. host card). If you are using a …
Knowledge Base Article Tutorial Performance Display Setup Zero Clients
Last modified: July 31, 2023
935
Why is my display not working correctly when using an adaptor attached to my OEM supplied cable?
Problem After purchasing a HP Anyware product you discover the cable shipped with the HP Anyware product does not have the necessary Video/Display connector to interface with your GPU or monitor. To complete the connection an adaptor is used to change the …
Knowledge Base Article Troubleshooting Display Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
869
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support HDMI connections?
PCoIP zero clients only come with the following connections: sVGA DVI (single and dual link) Display Port (1.1a) HDMI is not a supported connector type on PCoIP Zero Clients. You can purchase Display Port or DVI to HDMI cables and adapters however you may …
Knowledge Base Article Advisory Display Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2023
706
Why does the dual-link DVI monitor connected to my PCoIP Zero Client not display properly?
Check your DVI cable, it may not be dual-link capable. Dual-link cable ends have all of the pins populated whereas single-link cables are missing 6 pins. These pins carry the extra information to allow up to 2560 x 1600 resolution. Some monitors will …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: November 22, 2022
684
Why do my PCoIP Zero Client image settings have no effect when I change them?
Problem When connecting to your HP Anyware PCoIP Agent or VMware Horizon VM you may notice that the PCoIP Zero Client imaging settings have no effect on the PCoIP Session. The pcoip_server log file and the PCoIP Zero Client AWI both indicate the imaging …
Knowledge Base Article Troubleshooting Session Display Zero Clients
Last modified: September 7, 2023
630
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
596