What is Intelligent Packet Re-Transmission in PCoIP Protocol?
PCoIP Protocol uses UDP protocol similar to other real-time protocols (voice-over-IP, interactive video conferencing etc).  This is done to minimize the overhead associated with TCP protocol.  However, reliable transmission of data is important for remote …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
204
Can I share the network connection of the PCoIP Remote Workstation Card with that of the host PC/workstation?
No, the network interface on the PCoIP Remote Workstation Card is independent to that of the host. It is not possible to communicate to the host operating system via the PCoIP Remote Workstation Card network interface. Therefore, you must connect both the …
Knowledge Base Article Advisory Setup Remote Workstation Card
Last modified: July 3, 2020
197
What happens when a PCoIP Packet is lost in transit?
When a PCoIP packet is lost or considered lost, the PCoIP protocol makes an intelligent decision on if the packet should be re-transmitted. PCoIP packets containing audio and sometimes imaging may never be re-transmitted as the next sample of audio or new …
Knowledge Base Article Advisory Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
193
What congestion avoidance should be used in network switches and routers?
Weighted Random Early Discard (WRED) should be configured as the congestion avoidance, or congestion management method. WRED gradually drops packets while considering IP precedence, as network devices become congested. This allows PCoIP protocol …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
193
Is there any bandwidth consumed when a PCoIP device is idle?
The idle bandwidth depends on the PCoIP host type. Below are the idle bandwidths for different host types: HP Anyware 2.12 and newer, the idle bandwidth consumed is 1-2 kbps. VMware View 4.5 (using PCoIP Software 3.5) and earlier, the idle bandwidth …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: August 7, 2023
193
Why does traffic to my PCoIP Remote Workstation Card exceed the configured bandwidth settings?
Problem After setting the bandwidth limits on the PCoIP Remote Workstation Card in the PCoIP Remote Workstation Card AWI, excessive traffic is seen going to the PCoIP Remote Workstation Card from the PCoIP Zero Client. Cause PCoIP Remote Workstation …
Knowledge Base Article Troubleshooting Performance Remote Workstation Card Zero Clients
Last modified: September 3, 2023
190
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
Knowledge Base Article Troubleshooting Session Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 7, 2023
188
What does GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout mean in the log?
Problem Message GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout is found in host or client log file.   Cause GSOAP is the protocol used by the PCoIP Management Console 1.x. This error is caused by a socket being opened by GSOAP and not closed …
Knowledge Base Article Troubleshooting Management Management Console Remote Workstation Card Zero Clients
Last modified: September 8, 2023
186