How to disable all USB devices but allow Human Interface Devices (HID) using the PCoIP Management Console
The PCoIP Management Console 1.x, 2.x and 3.x can push predetermined profiles to PCoIP Zero Clients and PCoIP Remote Workstation Cards. Inside the profile USB policies that control USB authorized and unauthorized devices. In many organizations it is …
Knowledge Base Article Tutorial Peripheral Devices Management Console Remote Workstation Card
Last modified: September 3, 2023
1198
Why is USB not working when connecting a PCoIP Zero Client to a PCoIP Remote Workstation Card?
By default, all USB devices are bridged to the host with the PCoIP Remote Workstation Card and is dependent on the host OS. Please verify the following Make sure the USB devices are not unauthorized in the PCoIP Remote Workstation Card or PCoIP Zero …
Knowledge Base Article Troubleshooting Peripheral Devices Remote Workstation Card Zero Clients
Last modified: September 3, 2023
1176
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
990
Are there any limitations on physical distance for a PCoIP session?
Due to the design of PCoIP, using UDP for data transmission, PCoIP will operate over vast distances and network latencies up to 250 ms. PCoIP intelligently acknowledges the traffic inside the protocol allowing for high speed transmission over high latency …
Knowledge Base Article Tutorial Session Performance HP Anyware Remote Workstation Card
Last modified: May 22, 2024
887
How do I configure a Peer-to-Peer Connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card?
Requirements This article describes the configuration of a peer-to-peer, or dedicated connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card including dual and quad display scenario's. Single or dual display requires a single PCoIP …
Knowledge Base Article Tutorial Session Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2018
841
Connecting a new PCoIP Zero Client to an existing PCoIP Remote Workstation Card.
In general, newer firmware in PCoIP Remote Workstation Cards (host cards) are backward compatible with PCoIP Zero Clients using older firmware. However, enhancements to firmware may produce unexpected behaviors. Important changes are documented in each …
Knowledge Base Article Troubleshooting Session Remote Workstation Card Zero Clients
Last modified: September 19, 2023
625
Why does my PCoIP Remote Workstation hibernate or sleep and not power off remotely from my Tera 2 PCoIP Zero Client?
When a PCoIP Zero Client attempts to power down a Windows 7 or Windows 10 workstation host during a PCoIP session, the workstation may enter the sleep state rather than being shutdown. This will occur if Windows is configured to map the PC power button to …
Knowledge Base Article Advisory Session Remote Workstation Card Zero Clients
Last modified: July 3, 2020
518
What types of USB devices are supported in Linux with the PCoIP Remote Workstation Card?
The Tera2 PCoIP Remote Workstation Card presents a Open Host Controller Interface (OHCI) and Enhanced Host Controller Interface (EHCI), supporting the USB 1.0 and USB 2.0 specifications respectively, via the PCIe 1x connector to the motherboard. If is up …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card
Last modified: August 2, 2023
387