PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
What are the requirements for USB 2.0 (EHCI) support on PCoIP Zero Clients?
Answer: EHCI (Enhanced Host Controller Interface) is a high-speed controller standard that is publicly documented and provides high speed USB functionality. Tera2 based PCoIP Clients support USB 2.0 (EHCI) out of the box on all firmware releases. The …
What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
What are the jumpers and LEDs on the Tera2 PCoIP Remote Workstation Card used for?
All external connectors on Tera2 PCoIP host cards are for diagnostic purposes. Jumpers J15 and J25 are configurable and their functions are described below. If you want Tera1 jumper explanations instead, refer to  What are the jumpers on the Tera1 host …
Why do I get a gray screen when connecting from the HP Anyware PCoIP Software Client to a PCoIP Remote Workstation Card?
Answer: To resolve this issue, please make sure that you have the following installed and set correctly on the host PC/workstation - i.e. a computer with a PCoIP Remote Workstation Card (host card) installed: The host card should be running PCoIP firmware …
Where can I find a PCoIP-compatible connection broker?
In additional to HP Anyware Manager, as part of the Technology Partner Program, HP Anyware enables companies to build support for PCoIP session brokering. The following is a list of PCoIP compatible connection brokers:   Company Product Compatible with …
Is a 2560x1600 display resolution supported by PCoIP hardware devices?
PCoIP Zero Clients and PCoIP Remote Workstation Cards (host cards) support 2560x1600 based on the following: Firmware 4.0.3 and newer TERA2140 Supports a maximum resolution for two monitors of 2560x1600 @60Hz Supports a maximum resolution for four …