Requirements for the Leostream broker to automatically detect a PCoIP Remote Workstation Card?
Requirements For the Leostream broker to automatically detect a Remote Workstation Card the following components must be installed: PCoIP Remote Workstation Card inserted in the host PC Leostream Connection Broker 7.7 or newer Leostream Agent 5.5.95 or …
Why do I see black bars on the side or bottom of my display when connecting to a zero client?
Scenario : When connecting a display (TV or monitor) to a PCoIP zero client you get solid black bars at the top and bottom or left and right sides of the display. It appears as if the image is being cut off. Resolution : This issue is caused by ' …
Profile application to Remote Workstation Card fails
Scenario : The remote workstation card is at a factory default. You set a basic Profile in the management console and apply the Profile. The Profile application fails. If you check the management console, there is no clue as to why the Profile failed. If …
What does "MCU not initialized" log message mean?
Problem You are unable to manage a zero client using the HP Anyware PCoIP Management Console 1.x (MC). The event logs reveal the following MCU errors: LVL:1 RC:-500        MCU :(tera_mcu_read_eeprom_bit): Cannot read from EEPROM, MCU not initialized. …
Why is the host PC on my VMware Horizon brokered Remote Workstation Solution unable to wake up?
Scenario When a View Connection Server brokers a workstation connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card, and the host is put into any low power state (sleep, hibernate or shutdown); the client is unable to wake the host and …
Management Console profile is not applied to the Remote Workstation Card
Applying a Profile to a Remote Workstation Card from PCoIP Management Console will be unsuccessful if the Enable Audio setting on the Remote Workstation Card has never been enabled (default is disabled) or the Remote Workstation Card has not had the …
Could the use of two DVI channels be a sources for delay which might cause jitter in a PCoIP Remote Workstation Card configuration?
Using the two DVI channels on a PCoIP Zero Client to PCoIP Remote Workstation Card with the Dual-link DVI connector converter to achieve a 2560x1600 resolution is NOT a source for delay which might cause jitter. The use of two DVI channels could be one of …
Why is the image quality reduced for a couple seconds right after a session is connected?
This is expected behaviour during the first couple seconds when a PCoIP session is established and is caused by the PCoIP device's bandwidth management algorithm. The algorithm continuously optimizes the amount of network traffic a PCoIP device generates …
What does GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout mean in the log?
Problem Message GSOAP :tera_gsoap_tls_shutdown: tera_rtos_event_get timeout is found in host or client log file.   Cause GSOAP is the protocol used by the PCoIP Management Console 1.x. This error is caused by a socket being opened by GSOAP and not closed …