How do I find the IP address of my newly installed PCoIP Zero Client or PCoIP Remote Workstation card?
Answer: You can determine the IP address associated with your device using one of the following methods: Before you begin, write down the MAC address of the device you want to determine the IP address of. For most of these methods, the MAC address is …
Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
7846
Using HP Anyware PCoIP Zero Clients and Remote Workstation Cards on a direct-connect (no IP) network
Direct-connect (no IP network) configurations, sometimes incorrectly referred to as "home-run networks", refer to a direct connection between 2 devices without network switches/hubs installed using straight through cables via patch-panels. Although zero …
Knowledge Base Article Tutorial Performance Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
5183
Why does the "Source signal on other port" message appear on my display?
This indicates that a video source connected to the Host does not correspond with the video port used on the PCoIP Zero Client. This can be corrected by either swapping the video ports used on the Host or the PCoIP Zero Client. The following shows two …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
4888
Host Display Health Check - Diagnostics and troubleshooting guide
Summary To receive a detailed host diagnostic report, create a host agent  support/log file bundle  and then submit this bundle to the PCoIP  health check   tool.  Once the files are submitted, it will take 5-10 minutes to produce a detailed report.  The …
Knowledge Base Article Diagnostics Display HP Anyware Remote Workstation Card
Last modified: September 3, 2023
4141
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
Knowledge Base Article Troubleshooting Setup Management Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3960
PCoIP display is 'blurry' and the image is of lower than expected quality
Problem When using PCoIP the display is 'blurry' or of low quality. The display may be persistently blurry or is blurry intermittently and slow.    Cause Typically a blurry screen is due to the lack of bandwidth. Throughout a PCoIP session, PCoIP network …
Knowledge Base Article Troubleshooting Performance Display Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
3833
What does the 'No source signal' message mean?
The answer depends on what type of host the PCoIP Zero Client is connected to.  VMware View 4.5 or newer The message "no source signal" appears as an overlay when the VMware View virtual desktop puts the monitors to sleep.  Pressing a key or moving the …
Knowledge Base Article Troubleshooting Display HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3561
What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3543