How do I enable and disable the PCoIP Zero Client session disconnect CTRL-ALT-F12 key sequence?
Enable When using a PCoIP Zero Client to connect to HP Anyware, Amazon Workspaces or VMware Horizon View the Ctrl-Alt-F12 shortcut is enabled by default. This setting can be configured via the AWI or PCoIP Management Console. When using a workstation with …
Knowledge Base Article Tutorial Session Management Management Console Zero Clients
Last modified: September 3, 2023
1705
Host Session Health Check - Diagnostics and troubleshooting guide
Summary To receive a detailed host diagnostic report, create a host  support/log file bundle  and then submit this bundle to the PCoIP  health check   tool.  Once the files are submitted, it will take 5-10 minutes to produce a detailed report.  The report …
Knowledge Base Article Diagnostics Session Remote Workstation Card HP Anyware
Last modified: September 3, 2023
1613
What does "No Available Hosts for Connection" mean?
The message "No Available Hosts for Connection" appears if the PCoIP Zero Client has enabled the Host Discovery feature and tries to establish a session but cannot find a PCoIP Remote Workstation Card that is not currently in a session on the network. If …
Knowledge Base Article Troubleshooting Session Remote Workstation Card Zero Clients
Last modified: November 15, 2022
1523
What does the error message "Session Closed Remotely" mean?
There are a number or reasons that the message "Session Closed Remotely" appears during a brokered session listed below. Informational Messages Closed by login at an alternate location or host shutdown/restart User initiated logout Disconnected by …
Knowledge Base Article Advisory Session HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
975
Are there any limitations on physical distance for a PCoIP session?
Due to the design of PCoIP, using UDP for data transmission, PCoIP will operate over vast distances and network latencies up to 250 ms. PCoIP intelligently acknowledges the traffic inside the protocol allowing for high speed transmission over high latency …
Knowledge Base Article Tutorial Session Performance HP Anyware Remote Workstation Card
Last modified: December 9, 2022
883
How do I configure a Peer-to-Peer Connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card?
Requirements This article describes the configuration of a peer-to-peer, or dedicated connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card including dual and quad display scenario's. Single or dual display requires a single PCoIP …
Knowledge Base Article Tutorial Session Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2018
836
Connecting a new PCoIP Zero Client to an existing PCoIP Remote Workstation Card.
In general, newer firmware in PCoIP Remote Workstation Cards (host cards) are backward compatible with PCoIP Zero Clients using older firmware. However, enhancements to firmware may produce unexpected behaviors. Important changes are documented in each …
Knowledge Base Article Troubleshooting Session Remote Workstation Card Zero Clients
Last modified: September 19, 2023
614
How do I disable login username caching on a PCoIP Zero Client?
On a PCoIP Zero Client, username caching is set in the advanced options and can be disabled from the OSD Screen, the Administrative Web Interface (AWI), or the PCoIP Management Console.    From the OSD Screen: Under Options, select Configuration In the …
Knowledge Base Article Tutorial Setup Management Session Management Console Zero Clients
Last modified: September 3, 2023
576