Why is the BIOS not visible when my Dell workstation boots with a PCoIP Remote Workstation Card?
Scenario The BIOS on a Dell R5500/R5400 is not visible on boot up. After the OS loads, the monitor then displays the desktop. On some graphic cards, only the primary port is active during the POST phase of the host PC boot process. For example, when using …
Knowledge Base Article Troubleshooting Setup Display Remote Workstation Card
Last modified: September 3, 2023
1520
How can I determine the frame rate at a PCoIP protocol client?
Answer: There are a multiple ways to determine the frame update rate displayed at the PCoIP Zero Client.    Note: the frame rate displayed at the client this may be different than the source display frame rate when in a congested network environment.  Log …
Knowledge Base Article Tutorial Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: September 3, 2023
1505
Why can I not establish a PCoIP connection through my Palo Alto firewall?
Scenario With the PCoIP Transport Header enabled and using a Palo Alto firewall: PCoIP Zero Clients fail to open a session and show a black screen. The PCoIP Zero Client must be rebooted to get out of this state. Soft clients will only be able to connect …
Knowledge Base Article Troubleshooting Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: December 9, 2022
1475
How much latency does PCoIP technology add to the remote system?
The latency added by PCoIP technology to a remote system is related to the time to encode (compression) and decode (decompression) for the PCoIP protocol, which depends on the implementation. Total end-to-end latency is determined by OS latency and …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: July 28, 2023
1375
Host Performance Health Check - Diagnostics and troubleshooting guide
Summary To receive a detailed host diagnostic report, create a host agent  support/log file bundle  and then submit this bundle to the PCoIP  health check   tool.  Once the files are submitted, it will take 5-10 minutes to produce a detailed report.  The …
Knowledge Base Article Diagnostics Performance Remote Workstation Card HP Anyware
Last modified: June 28, 2024
1262
Determining why the PCoIP Zero Client was reset to factory default
Problem The PCoIP Zero Client unexpectedly reset to factory default.    Cause The PCoIP Zero Client would only reset to factory defaults if one of the reset options was used. The PCoIP Zero Client can be reset by the PCoIP Management Console, through the …
Knowledge Base Article Troubleshooting Management Management Console Zero Clients
Last modified: September 15, 2023
1108
Why are some Tera2 PCoIP Zero Clients showing the Online status as "False" in PCoIP Management Console 2.x and 3.x?
This indicates that the Tera 2 PCoIP Zero Client is not being managed by the PCoIP Management Console and can be one of several reasons: Not powered on Firmware has been downgraded to 4.x so no longer manageable by PCoIP Management Console 2.x and 3.x NTP …
Knowledge Base Article Troubleshooting Management Management Console Zero Clients
Last modified: September 3, 2023
1026