How to upload provisioning template and post script files to customer storage in HP Anyware Connectors for Azure
HP Anyware has changed the file names, locations and install paths of the PCoIP Agents. This KB provides instructions on how to update previously installed HP Anyware Connectors for Azure with these new locations to ensure that new remote workstations use …
Knowledge Base Article Tutorial Setup Management HP Anyware
Last modified: August 2, 2023
642
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
624
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
602
How do I update the HP Anyware registration code in HP Anyware Manager?
This article illustrates how to update the HP Anyware registration code in HP Anyware Manager. The steps in this article are for Microsoft Azure only.   Requirements HP Anyware Manager has been deployed, up and running. Admin access to HP Anyware Manager …
Knowledge Base Article Tutorial Licensing Management HP Anyware
Last modified: September 3, 2023
595
Why does the PCoIP Zero Client OSD image quality preference slider not have any effect on PCoIP session?
Answer: Activation of the  Image Quality Preference slider requires enablement of the  check box found in the  Configure PCoIP image quality levels  ADM GPO variable shown below.   The Image Quality Preference slider (shown below) resides in the OSD under …
Knowledge Base Article Troubleshooting Display Performance Zero Clients HP Anyware
Last modified: August 2, 2023
442
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
377