Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?

Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …

What is monitor emulation on the PCoIP Remote Workstation Card and how does it work?

Answer: Monitor emulation is a feature on the PCoIP Remote Workstation Card (also known as a host card) that ensures graphics cards see a valid EDID on a Display Port or DVI port on boot. This helps prevent the graphics card from driving DVI signals or DP …

How do I connect the PCoIP Remote Workstation Card's power button cable?

Review and carefully follow the steps below to install the power button cable. This allows you to use your PCoIP Zero Client to remotely power on (or off) a host machine that has a PCoIP Remote Workstation card (host card) installed. A. On the host card, …

How to upgrade PCoIP Management Console?

This is a high level KB article to give you migration path for your currently installed management console version. Path 1 - Upgrade from Management Console 1.x to Management Console version 1.1: How to upgrade PCoIP Management Console? Path 2 - Upgrade …

"No PCoIP devices detected. Please ensure the hardware is installed and the Host Driver Function is enabled on the PCoIP Host card prior to installing the software"

Problem When installing host software on a PC, the following error message may be displayed: "No PCoIP devices detected. Please ensure the hardware is installed and the Host Driver Function is enabled on the PCoIP Host card prior to installing the …

How do I enable NTP on PCoIP Zero Clients and PCoIP Remote Workstation Cards?

Enabling NTP is important on the PCoIP Zero Client and PCoIP Remote Workstation Card. NTP is using for the following: Setting the time and date of the PCoIP Zero Client and PCoIP Remote Workstation Card. As there is no battery on the devices, the time and …

How to change the Num Lock setting on a PCoIP Zero Client

The num lock ( numlock) setting depends on whether the PCoIP Zero Client is at the On-Screen-Display (OSD) or when in-session. On-Screen-Display operation The "Factory" default setting of num lock can be set by the PCoIP Zero Client OEM during …

How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?

Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …

What is the impact of power outage during firmware update?

Firmware 5.0.0 and newer Due to additional functionality added to the PCoIP Zero Client over time, there is no longer space for two complete firmware images. To prevent the PCoIP Zero Client from entering an unrecoverable state from a power outage during …

Knowledge Base Article Advisory Setup Zero Clients

Last modified: November 16, 2022

1575

How do I configure my 4 monitors in the PCoIP Zero Client OSD?

To configure 4 monitors to your preference, follow the steps below. Before you begin, make sure that you know what monitor is connected to what PCoIP Zero Client port number. From the onscreen display (OSD) of your PCoIP Zero Client, browse to Options > …

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics