How do I enable NTP on PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Enabling NTP is important on the PCoIP Zero Client and PCoIP Remote Workstation Card. NTP is using for the following: Setting the time and date of the PCoIP Zero Client and PCoIP Remote Workstation Card. As there is no battery on the devices, the time and …
How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?
Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …
Why are some Tera2 PCoIP Zero Clients showing the Online status as "False" in PCoIP Management Console 2.x and 3.x?
This indicates that the Tera 2 PCoIP Zero Client is not being managed by the PCoIP Management Console and can be one of several reasons: Not powered on Firmware has been downgraded to 4.x so no longer manageable by PCoIP Management Console 2.x and 3.x NTP …
Configuring and Installing External MongoDB and Vault using self-signed TLS Certificates
Overview The purpose of this document is to provide one-stop instructions of how to install and configure a instance of MongoDB and a instance of Vault on the same VM with the simplest single host deployment. This can be served as the pre-requisites steps …
How to remove expired license from MC 2.x or 3.x to switch from Enterprise Edition to Standard Edition?
NOTE: If you are running Management Console 2.x or 3.x in Enterprise Edition and your license has expired you will not be able to log into the Management Console until you have either deactivated all your expired licenses or have activated new licenses. …
My PCoIP Zero Clients at the remote location cannot connect to PCoIP Management Console 3.x
Problem PCoIP Zero Clients in remote locations are not connecting to the PCoIP Management Console 3.x   Cause This issue was tracked down to a setting in the PCoIP Management Console 3.x (MC). Check under Settings > Remote and confirm if you have entered …