Tera 2 PCoIP Zero Client and PCoIP Remote Workstation Card firmware prerequisites when upgrading to new firmware releases.
Answer Depending on the currently installed firmware version on your Tera2 device, an upgrade to new firmware may require an intermediate firmware upload. To upgrade the PCoIP Zero Client and PCoIP Remote Workstation Card firmware, follow the associated …
How do I find the IP address of my newly installed PCoIP Zero Client or PCoIP Remote Workstation card?
Answer: You can determine the IP address associated with your device using one of the following methods: Before you begin, write down the MAC address of the device you want to determine the IP address of. For most of these methods, the MAC address is …
Configuration of smart cards with PCoIP Zero Clients and VMWare Horizon
This article is provided to help administrators in setting up smart card authentication in zero clients connecting to VMWare Horizon. This article has been reviewed against the following supported hardware and software versions: VMware Horizon 7.2 PCoIP …
Using a custom display resolution and the Hot Plug Reset function on a PCoIP Zero Client
Setting a custom display resolution A PCoIP Zero Client allows you to set a custom display resolution on the client, which is saved even when the client is powered down. This lets you set a resolution that is different than the attached display's native …
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …
How do I enable NTP on PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Enabling NTP is important on the PCoIP Zero Client and PCoIP Remote Workstation Card. NTP is using for the following: Setting the time and date of the PCoIP Zero Client and PCoIP Remote Workstation Card. As there is no battery on the devices, the time and …
How do I reset the configuration parameters entered on my PCoIP Zero Client or PCoIP Remote Workstation Card?
Answer: There are four ways to reset the PCoIP Zero Client to default settings which are described below. The PCoIP Remote Workstation card (also known as a PCoIP host card) has one reset procedure also described below. Some network information will be …