Tera 2 PCoIP Zero Client and PCoIP Remote Workstation Card firmware prerequisites when upgrading to new firmware releases.
Answer Depending on the currently installed firmware version on your Tera2 device, an upgrade to new firmware may require an intermediate firmware upload. To upgrade the PCoIP Zero Client and PCoIP Remote Workstation Card firmware, follow the associated …
PCoIP TROUBLESHOOTING STEPS: VMware View Virtual desktop performance
This article provides a brief list of general troubleshooting steps for performance issues on virtual desktops. Scenarios covered include: Video slicing or tearing. Screen (or parts of the screen) becomes fuzzy screen and then clears up. Slow screen …
How do I find the IP address of my newly installed PCoIP Zero Client or PCoIP Remote Workstation card?
Answer: You can determine the IP address associated with your device using one of the following methods: Before you begin, write down the MAC address of the device you want to determine the IP address of. For most of these methods, the MAC address is …
How do I check for packet loss on the ESX interface?
If there is packet loss on a PCoIP protocol session, but an analysis of network devices in the path show no loss and they have been properly configured (see  Network session checklist for PCoIP protocol LAN and WAN deployments ) then you may want to …
What causes a firmware upgrade failure?
Problem Uploading firmware through the AWI or a PCoIP Zero Client or PCoIP Remote Workstation Card fails with an error message. Applying firmware through the PCoIP Management Console fails.   Cause and Solution There are multiple scenarios that can cause …
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
What are the jumpers and LEDs on the Tera2 PCoIP Remote Workstation Card used for?
All external connectors on Tera2 PCoIP host cards are for diagnostic purposes. Jumpers J15 and J25 are configurable and their functions are described below. If you want Tera1 jumper explanations instead, refer to  What are the jumpers on the Tera1 host …
What is monitor emulation on the PCoIP Remote Workstation Card and how does it work?
Answer: Monitor emulation is a feature on the PCoIP Remote Workstation Card (also known as a host card) that ensures graphics cards see a valid EDID on a Display Port or DVI port on boot. This helps prevent the graphics card from driving DVI signals or DP …
What are the factory default network settings for PCoIP Zero Clients and PCoIP Remote Workstation Cards?
Answer: An OEM may change the factory default network settings. Please refer to your OEM's manual for detailed information. Most devices generally have the following factory default network settings: DHCP enabled Fallback IP address (PCoIP Remote …