What are the supported monitor resolutions and refresh rates for PCoIP Zero Clients and Remote Workstation Cards?
In general, PCoIP zero clients and Remote Workstation cards should work with standard display resolutions supported by VESA. The following is a list of the tested monitor resolutions supported (display timing); all at 60 Hz display refresh rate. …
Knowledge Base Article Advisory Display Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3582
Why does an EDID read failure cause my display attached to the PCoIP Zero Client to using a lower resolution than expected.
Problem The monitor attached to the PCoIP Zero Client is using a resolution much lower than expected.  The attached devices on the AWI \u2192 Info \u2192 Attached devices show EDID read failure. The Display Topology section in the zero client log file …
Knowledge Base Article Troubleshooting Display Zero Clients
Last modified: September 3, 2023
3333
FAQ - HP Anyware Manager and HP Anyware Connector
This article provides common questions and answers about HP Anyware Manager (previously HP Anyware Manager). It includes concepts, guidelines and troubleshooting checklists and links to the product documentation instructions found in the various HP …
Knowledge Base Article FAQ Setup HP Anyware
Last modified: September 12, 2023
3170
How do I Set Zero Client password in PCoIP Management Console?
Use PCoIP Management Console PCoIP Management Console is recommended to manage the password setup for zero clients, including enabling the password protection for OSD and AWI, setting the password, and whether or not hiding the Password options from OSD …
Knowledge Base Article Tutorial Authentication Management Management Console Zero Clients
Last modified: September 3, 2023
3118
Can multiple PCoIP Zero Clients connect to multiple PCoIP Remote Workstation Cards in a workstation/PC simultaneously?
You can install multiple PCoIP Remote Workstation Cards (host cards) into a workstation/PC and have multiple PCoIP Zero Clients connecting to them simultaneously. Each PCoIP Zero Client must have 1 PCoIP Remote Workstation Card. PCoIP Zero Clients can …
Knowledge Base Article Advisory Setup Remote Workstation Card Zero Clients
Last modified: September 3, 2023
3093
Why does the "USB device not authorized"message appear on my display?
This message indicates that an unauthorized USB device is attached to the PCoIP Zero Client. Be sure allowed USB devices are specified in the list of authorized devices and not in the list of unauthorized devices in the USB page of the PCoIP Zero Client's …
Knowledge Base Article Troubleshooting Peripheral Devices Zero Clients
Last modified: September 3, 2023
2949
What are the jumpers and LEDs on the Tera2 PCoIP Remote Workstation Card used for?
All external connectors on Tera2 PCoIP host cards are for diagnostic purposes. Jumpers J15 and J25 are configurable and their functions are described below. If you want Tera1 jumper explanations instead, refer to  What are the jumpers on the Tera1 host …
Knowledge Base Article Troubleshooting Setup Remote Workstation Card
Last modified: April 17, 2024
2885
What is an acceptable level of packet loss?
Just like VoIP and video conferencing, PCoIP is a real time protocol. Once a packet is lost in transit, there typically isn't time to re transmit before the PCoIP session is impacted. Therefore, the most acceptable level of loss is 0%. Packet loss maybe …
Knowledge Base Article Advisory Performance HP Anyware Remote Workstation Card Zero Clients
Last modified: September 3, 2023
2762