How do I enable and disable the PCoIP Zero Client session disconnect CTRL-ALT-F12 key sequence?
Enable When using a PCoIP Zero Client to connect to HP Anyware, Amazon Workspaces or VMware Horizon View the Ctrl-Alt-F12 shortcut is enabled by default. This setting can be configured via the AWI or PCoIP Management Console. When using a workstation with …
Knowledge Base Article Tutorial Session Management Management Console Zero Clients
Last modified: September 3, 2023
1737
Mirroring displays on PCoIP Zero Clients
Requirements Tera2 dual port client (TERA2321) Firmware 4.1 or newer   Instructions From the PCoIP Zero Client's onscreen display (OSD) or both versions of the Management Console OSD - browse to Options > Configuration > Display > Enable Display Cloning …
Knowledge Base Article Tutorial Display Zero Clients
Last modified: November 7, 2022
1246
Displays
After completing this unit, you’ll be able to: Understand the different display configurations. Understand the supported resolutions 20 mins With PCoIP, you can configure several display settings as described below.   Display Resolutions PCoIP supports …
Knowledge Base Article Tutorial Display HP Anyware
Last modified: September 5, 2023
1165
How do I change the image quality properties of a PCoIP Remote Workstation Card?
Review the below table to understand where to change the image quality properties in a remote workstation environment. This information applies to sessions between PCoIP Zero Clients and a PCoIP Remote Workstation Card (i.e. host card). If you are using a …
Knowledge Base Article Tutorial Performance Display Setup Zero Clients
Last modified: July 31, 2023
952
Are there any limitations on physical distance for a PCoIP session?
Due to the design of PCoIP, using UDP for data transmission, PCoIP will operate over vast distances and network latencies up to 250 ms. PCoIP intelligently acknowledges the traffic inside the protocol allowing for high speed transmission over high latency …
Knowledge Base Article Tutorial Session Performance HP Anyware Remote Workstation Card
Last modified: May 22, 2024
894
How do I configure a Peer-to-Peer Connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card?
Requirements This article describes the configuration of a peer-to-peer, or dedicated connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card including dual and quad display scenario's. Single or dual display requires a single PCoIP …
Knowledge Base Article Tutorial Session Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2018
847