Teradici Documentation and Downloads | Documents and Downloads for Teradici products

Sort by

Using an resolutions lower than 1024x768 with a PCoIP Zero Client

Scenario When forcing the screen resolution via the OSD Options>Configure>Display dialog box, if the resolution is set smaller than 1024x768 then display parameters can no longer be changed via the OSD's user interface as portions of the dialog box fall …

Knowledge Base Article Tutorial Display Zero Clients

Last modified: November 14, 2022

468

PCoIP Zero Client Display Topology Alignment settings

The Alignment setting in the OSD Display Topology tab is designed to work with 2 or more monitors with different resolutions. It is also designed to work if one of the two monitors with identical resolutions is rotated to portrait mode. The Alignment …

Knowledge Base Article Tutorial Display Zero Clients

Last modified: November 8, 2022

451

How long does it take a proximity reader to enumerate?

The proximity readers that have been tested with PCoIP Zero Clients typically enumerate in under 5 seconds; however, there can be exceptions. RF Ideas Air ID 82 Series RDR-7L82AKU (LEGIC-Prime only) proximity reader has been seen to take longer and is …

How can I tell if the 802.1x certificate uploaded successfully?

A good test is to use the web UI to upload the 802.1x certificate. From the web UI, go to Upload> Certificate and view the screen. If the certificate is listed after a restart of the PCoIP Zero Client then the certificate was uploaded successfully (see …

When the network experiences periods of high congestion what will happen to the users experience?

PCoIP will adjust to the network conditions to deliver the best PCoIP experience possible, for the given network conditions, for the user. During periods of congestion the user experience: A blurry or compressed image Momentary block screens Stuttering …

Can I add software to or change the operating system of a PCoIP Zero Client?

PCoIP Zero Clients do not run local application software. They run secure custom firmware created by HP Anyware only. This makes them extremely secure PCoIP Clients allowing for simple management and updates through small firmware updates. New features …

Knowledge Base Article Tutorial Setup Zero Clients

Last modified: September 22, 2023

233

Is there any information left on my PCoIP Zero Client after a reset is performed?

When a PCoIP Zero Client is factory reset, the following information will still reside in flash: If a PCoIP Zero Client is connected to a network during the reset process, the logs will catch the normal network information on start up as part of its …

Knowledge Base Article Tutorial Security Zero Clients

Last modified: November 18, 2022

207

Filter by Products

Filter by Topics

Search Knowledge Center

Filter by Products

Filter by Topics