How do I identify if enhanced logging is enabled on PCoIP Zero Clients and PCoIP Remote Workstation cards?
Answer: Since firmware 4.0.0, enhanced logging has been identifiable in events logs on PCoIP Zero Clients and PCoIP Remote Workstation Cards (also known as a host card). Event log entries of no module selected indicate enhanced logging is not activated …
Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Last modified: October 27, 2022
1338
How do I configure a Peer-to-Peer Connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card?
Requirements This article describes the configuration of a peer-to-peer, or dedicated connection between a PCoIP Zero Client and a PCoIP Remote Workstation Card including dual and quad display scenario's. Single or dual display requires a single PCoIP …
Knowledge Base Article Tutorial Session Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2018
836
How to configure a PCoIP Zero Client to auto-connect to a Remote Workstation Card
Answer: To enable auto connect, you need to peer the PCoIP Zero Client to the Remote Workstation Card. You will need the IP and MAC of the host. You enter this in the PCoIP Zero Client's configuration (On Screen Display or Administrative Web Interface), …
Knowledge Base Article Tutorial Setup Remote Workstation Card Zero Clients
Last modified: September 14, 2023
566
How do I configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card?
There are three ways to configure wake-on-LAN with the AMD R5000 PCoIP Remote Workstation Card. Option 1: Use the PC NIC and PCoIP Host Software  For instructions, refer to How do I remotely power on the host PC/workstation through its network interface …
Knowledge Base Article Tutorial Setup Remote Workstation Card
Last modified: August 23, 2018
256