Can I connect a local monitor to computer that has PCoIP Remote Workstation Card or HP Anyware Installed?
Although you may have enough display heads on your GPU to connect local monitors, it is not a supported configuration when using a PCoIP Remote Workstation Card or HP Anyware. Connecting an additional local monitor may cause the following issues: Blank …
Knowledge Base Article Advisory Display HP Anyware Remote Workstation Card
Last modified: July 31, 2023
851
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support HDMI connections?
PCoIP zero clients only come with the following connections: sVGA DVI (single and dual link) Display Port (1.1a) HDMI is not a supported connector type on PCoIP Zero Clients. You can purchase Display Port or DVI to HDMI cables and adapters however you may …
Knowledge Base Article Advisory Display Setup Remote Workstation Card Zero Clients
Last modified: July 31, 2023
705
What is the impact of minimum and maximum initial image quality on a PCoIP Session?
Minimum and maximum initial image quality sets the lower and upper quality level. The default values in HP Anyware is Q40 for the minimum initial image quality and Q80 for the maximum initial image quality. If PCoIP estimates there is adequate bandwidth …
Knowledge Base Article Advisory Display Performance Remote Workstation Card HP Anyware
Last modified: July 31, 2023
610
Should I use an initial image quality of Q100?
An initial image quality of Q100 will deliver the highest quality of image PCoIP can deliver. Q100 is not lossless, for a lossless image, build to lossless must be enabled.  How to configure the Turn off Build-to-Lossless feature session variable in GPO …
Knowledge Base Article Advisory Display Performance Remote Workstation Card Zero Clients HP Anyware
Last modified: August 1, 2023
595
What are the cabling requirements in a Remote Workstation Card environment?
Answer: HP Anyware PCoIP Remote Workstation Cards and PCoIP Zero Clients are designed considering port pass through and should be connected in a specific manner to limit potential display issues. In a PCoIP workstation environment ensure the connection …
Knowledge Base Article Advisory Display Remote Workstation Card
Last modified: August 2, 2023
441
What types of USB devices are supported in Linux with the PCoIP Remote Workstation Card?
The Tera2 PCoIP Remote Workstation Card presents a Open Host Controller Interface (OHCI) and Enhanced Host Controller Interface (EHCI), supporting the USB 1.0 and USB 2.0 specifications respectively, via the PCIe 1x connector to the motherboard. If is up …
Knowledge Base Article Advisory Peripheral Devices Remote Workstation Card
Last modified: August 2, 2023
384
Should I configure "Maximum Initial Image Quality" to 100 if I want lossless still image?
No. Regardless of PCoIP image-quality settings, still images are always lossless. The time it takes to display them depends on your image-quality settings and available network bandwidth. For most situations, it is recommended to use 40 for Minimum Image …
Knowledge Base Article Advisory Performance Display Remote Workstation Card HP Anyware Zero Clients
Last modified: December 9, 2022
365
Which PCoIP products support Wacom devices?
Wacom devices are supported by PCoIP using 2 different connection methods. Each connection method has it's pros and cons and the most suitable should be selected for your scenario.   Bridged USB device When using the Wacom device as a bridged USB device, …
Knowledge Base Article Advisory Peripheral Devices
Last modified: September 3, 2023
272